How to Tap a Keg: Party Pump and CO2 Basics (Step by Step)
Updated 2026-11-19
Most US kegs use a D-system Sankey valve. You’ll attach either a party pump (hand pump, usually rented from the store) or a CO2 coupler (kegerators and jockey boxes). Imported kegs may need a different coupler, so ask the store.
Before you tap
- Keep it cold. Beer pours best around 36–38 °F. Put the keg in a tub with plenty of ice (around the sides, and on top).
- Let it settle. A keg that was just driven around will foam; give it time to rest before tapping.
- Check the coupler. The handle should be in the up/disengaged position before you attach it.
Tapping with a party pump
- Remove the plastic cap or seal from the keg valve.
- Line up the coupler’s lugs with the slots on the valve, push down, and turn clockwise about a quarter turn until snug.
- Pull the handle out and press it down until it locks. The keg is now tapped.
- Pump a few times only, then pour into a tilted cup. Pump again only when the flow slows down. Over-pumping is the #1 cause of foam.
- Expect the first pours to be foamy; that’s normal.
A party pump pushes outside air into the keg, so the beer starts to go stale fairly quickly – plan to finish it within about a day. A CO2 system keeps beer fresh much longer.
Tapping with CO2 (kegerator or jockey box)
- Connect the gas line to the regulator and the coupler; set the regulator to the pressure your system’s instructions recommend (commonly around 10–14 psi for typical American lagers in a kegerator).
- Attach and engage the coupler exactly as above.
- Open the gas and pour. If it foams, check temperature first, then pressure.
Untapping
- Pull the handle up to disengage.
- Turn the coupler counter-clockwise and lift it off.
- Never try to remove the keg’s valve (spear); kegs are under pressure. Return the keg with the tag attached to get your deposit back.